La Crosse Technology WS-9626U-IT - Manuel (Page 10)

9
Note:
The indoor receiver registers the temperature by default in Farenheit (°F), but user can manually
set to Celsius (°C) ONLY after the initial set-up is complete as instructed in the manual. After the
LCD shows the temperature readings from the outdoor transmitter, user may set the
temperature unit to °C (See Manual Settings below).
When more than one transmitter is to be used
1.
User shall remove all the batteries from the temperature station and transmitters and wait 60
seconds if setting has been done with one transmitter before.
2. Insert the batteries to the first transmitter.
3. Within 30 seconds of powering up the first transmitter, insert the batteries to the Weather Station.
Once the batteries are in place, all segments of the LCD will light up briefly. Following time as
12:00 and the weather man icon will be displayed. If they are not shown in LCD after 60 seconds,
remove the batteries and wait for at least 60 seconds before reinserting them.
4. The outdoor temperature from the first transmitter (channel 1) should then be displayed on the
Weather station. Also, the signal reception icon will be displayed. If this does not happen after 2
minutes, the batteries will need to be removed from both units and reset from step 1.