SVAT Electronics 2.4 GHz Wireless B/W Security System - Manuel (Page 9)

Setting Up-Camera
Power Supply 1
The camera uses either batteries (AA-size) or household AC current.
To Load Batteries
Open the battery compartment cover.
Slide the POWER Switch to the ON position. The LED on the back of the camera should
light.
Never mix old batteries with new ones.
Remove batteries from the camera if you do not plan to use it for a period of time.
Using AC Power
Plug one end of the provided power adapter into a wall outlet and the other end into the rear
of the camera.
Note: Use the adapter labeled OUTPUT: 9V DC.
Insert batteries so their plus (+) and minus (-) ends are
facing as shown in the illustration.
Close the battery compartment cover. Make sure the
battery compartment cover is locked securely.
7
1
2
3
PDF created with FinePrint pdfFactory trial version www.pdffactory.com