SVAT Electronics 2.4 GHz Wireless B/W Security System - Manuel (Page 17)

15
If you are not getting any signal at all
• Check the power on the camera and monitor
• Make sure power plugs are pushed all the way in
• Check the CHANNEL switches on both camera and monitor are set to the same number
• If the camera/monitor is powered by batteries, replace all batteries with new ones
• If you can receive sound, but don't have images, or the images are poor, check the SCREEN ON/
OFF button on the front panel, or adjust the V-HOLD/ CONTRAST/BRIGHTNESS knob on the
rear of the monitor
If the signal is poor, or there is interference
• Adjust antenna orientation
• Change the channel settings on both camera and monitor and make them the same
• If there is a microwave oven in use in the path between the camera and monitor, remove the
microwave oven or turn it off
• Make sure the camera and monitor are within range (up to 300 feet)
• Check the channel dipswitch positions on the monitor.
Troubleshooting
PDF created with FinePrint pdfFactory trial version www.pdffactory.com