Changing the setup of the port – Intel EXPRESS 550T Manuel d'utilisation
Page 67
57
57
C H A P T E R 3
Standard Configuration
5
Click
OK
.
Changing the forward
delay expiry time
To change the time between port states while the bridge attempts to
become the root:
1
Select
Device Setup
or
Stack Setup
.
2
Click
Spanning Tree
.
3
Click
Forward Delay Timer Expiry
.
4
Type the required number of seconds.
5
Click
OK
.
Changing the state of the
ports
To specify that all ports are using Spanning Tree Protocol:
1
Select
Device Setup
or
Stack Setup
.
2
Click
Spanning Tree
.
3
Click
Enable All Ports
.
The ports are able to resolve problematic network loops using
STP.
4
Click
OK
.
Changing the Setup of the
Port
Purpose
You can configure the port to operate in different ways, according to
your network’s requirements:
•
Change the port state
•
Select the auto-negotiation mode
•
Change each port to half or full duplex
(If auto-negotiation is not enabled)
•
Specify the speed of the port
(If auto-negotiation is not enabled)
•
Change the forwarding mode of the port
•
Change the flow control setting of the port
500.book Page 57 Thursday, September 2, 1999 1:50 PM