Intel EXPRESS 550T - Manuel (Page 135)

125
125
C H A P T E R 8 Console Port Use and Troubleshooting
Upgrading Software If a working switch software needs to be upgraded, it is recommended
to use the Software Upgrade Wizard in Intel Device View rather than
the maintenance mode commands. This is easier and the existing con-
figuration is retained.
Switch Configuration The configuration information for the switch is stored in two files re-
siding in flash memory. The two files are named after the MAC ad-
dress of the switch. One of them, inxxxxxx.p, contains all the basic
configuration parameters, while the other, STDALONE.nvp, con-
tains the VLAN policy database.
Backing up the
Configuration The two configuration files may be backed up using a TFTP client on
an external machine (e.g. MS Windows*, Unix* or other). Please fol-
low the documentation for the TFTP client application for further in-
structions. However, it is recommended to use Intel Device View for
doing backup of the configurations.
Restoring the
Configuration The two configuration files may be restored using a TFTP client on
an external machine (e.g. MS Windows*, Unix* or other), if the
switch configuration has been lost or corrupted. It is recommended to
use Intel Device View for restoring the configurations rather than
manual TFTP.
Reset to Factory Defaults If the configuration in the switch has been corrupted in such a way
that the switch is not able to start properly after reset (System LED
goes red), it may be necessary to reset the switch configuration to fac-
tory defaults. The RUN Defparm command may be used to do this.
Please note, that this will discard the existing configuration in the
switch. This method may also be used, if the configuration by mistake
has made it impossible to contact the switch by other means. It is also
the only way to regain access to the switch, if the administrator pass-
word has been lost.
500.book Page 125 Thursday, September 2, 1999 1:50 PM