Maytag W10338688B - Manuel (Page 13)

13
TROUBLESHOOTING
Plug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker. Replace any blown fuses.
NOTE: If problems continue, contact an electrician. Check for proper electrical
supply.
Washer won’t run
or fill, washer stops
working or wash light
remains on (indicating
that the washer
was unable to fill
appropriately) (cont.)
If you experience Possible Causes Solution
Washer not performing as expected cont.
Normal washer operation. Lid must be closed for washer to run.
Washer will pause during certain phases of cycle. Do not
interrupt cycle.
Washer may be stopped to reduce suds.
The washer senses the dry load with short spins that may take
2 to 3 minutes before water is added. You may hear the hum of the
spins. This is normal.
Washer may be tightly packed. Remove several items, rearrange load evenly around the washplate.
Do not load garments directly over the center of the washplate.
Close lid and press START/Pause/Unlock.
Add only 1 or 2 additional garments after cycle is started.
Not using HE detergent or using too
much HE detergent.
Only use HE detergent. Suds from regular detergents can slow or
stop the washer. Always measure detergent and follow detergent
directions based on your load requirements.
To remove suds, cancel cycle. Select Rinse & Spin. Press START/
Pause/Unlock. Do not add more detergent.
Do not add more water to the washer.
First try the solutions suggested here or visit our website at www.maytag.com/product_help -
In Canada, www.maytag.ca, for assistance and to possibly avoid a service call.