GE 48 - Manuel (Page 38)

11A INSTALL DOOR PANELS
Install 1/4
″
Decorative Panels:
• Remove Pre-Installed Handles
Open door to 90°. Remove 5 Phillips head
screws from the Fresh Food and Freezer door
handles; retain all screws. Lift off pre-installed
door handles.
• Install Door Panels
NOTE: Carefully push the Fresh Food panel in until
it slides into the slot behind the trim. Gently push
to opposite side. Repeat procedure for upper and
lower Freezer panels.
• Install Custom Trim
Install the custom trim with the original
5 Phillips head screws. Tighten. Repeat
for Freezer door.
NOTE: Ensure that the edge of the custom trim
does not pinch the door gasket.
• 3/4
″
Custom Decorative Panels
If you choose to install custom wood panels,
they must be cut to dimensions shown
on pages 23–30. The panels will slide
into the frame on the doors and grille.
If using custom handles, please see Door
Handles on page 20.
IMPORTANT NOTE: Maximum custom panel
thickness must not exceed 1-1/8
″
thick and 70 lbs
for the Fresh Food door, 45 lbs total for the Freezer
door and 15 lbs for the Grille panel.
Installation Instructions
38
Fresh Food
Refrigerator
Door
Handle
3/4" Custom Panel
if Required
Custom Trim