GE 48 - Manuel (Page 35)

7 LEVEL REFRIGERATOR
All models have 4-point leveling. The front and back
are supported by leveling legs. Both are accessible
from the front of the refrigerator.
• To level the back of the refrigerator, turn the 1/2
″
hex nut located above the front wheels. Turn
clockwise to raise or counterclockwise to lower
the refrigerator.
• For front leveling, use a 7/16
″
open-end wrench.
• Adjust height of refrigerator to match
installation cutout opening 83-1/2
″
to 84-1/2
″
.
The refrigerator should be level and plumb with
cabinets.
IMPORTANT NOTE: The refrigerator must be level.
If it is not, the doors may not align evenly at
the top. See Step 16.
CAUTION:
The rear leveling legs and front leveling legs
are limited to a maximum height adjustment
of 1
″
. If the installation requires more than 84-1/2
″
height, the installer should elevate the refrigerator
on a sheet of plywood or runners. Cabinet trim
could be added across the top of the opening
to shorten the opening. If you attempt to raise
the refrigerator more than 1
″
, you will damage
the front and rear leveling legs.
5 CONNECT POWER
• Connect refrigerator power cord plug to
a properly grounded receptacle. Set the
Master Power switch to the I (ON) position.
• Check to make sure power to refrigerator
is on by opening refrigerator door to see
if interior lights are on.
CAUTION:
• After power has been established, turn the
Master Power switch to the O (OFF) position.
6 MOVE INTO INSTALLATION SPACE
• Slide the unit into the installation space.
• Place excess slack in the power cord on top
of the refrigerator.
• Use care to ensure the power cord is not pinched
behind the unit.
Raise
Grille
Panel
Water Filter Master
Power Switch
Hex Nut Adjusts
Rear Leveling Legs
Leveling Leg
Height
from
Floor to
Bottom
of Wood
Block
82"
Installation Instructions
35