GE 48 - Manuel (Page 11)

11
About the ice and water dispenser.
ge.com
To Use the Dispenser
Select CUBED , CRUSHED
or WATER .
Press the glass gently against the middle
of the dispenser pad.
The spill shelf is not self-draining.
To reduce water spotting, the shelf and
its grille should be cleaned regularly.
If no water is dispensed when the
refrigerator is first installed, there may
be air in the water line system. Press
the dispenser arm for at least two
minutes to remove trapped air from
the water line and to fill the water
system. To flush out impurities
in the water line, throw away
the first six glassfuls of water.
CAUTION:
Never put fingers
or any other objects into the ice crusher
discharge opening.
Locking the Dispenser
Press the LOCK/LIGHT
button for 3 seconds
to lock the dispenser and
control panel. To unlock,
press and hold the button
again for 3 seconds.
Dispenser Light
This button turns
the night light on the
dispenser on and off.
The light also comes
on when the dispenser
pad is pressed. If this light
burns out, it should be
replaced with a 6 watt
12V maximum bulb.
Quick Ice
When you need ice
in a hurry, press this
button to speed up ice
production. This will
increase ice production
for the following
48 hours or until you
press the button again.
Door Alarm
To turn the Door Alarm
on, press the DOOR
ALARM button once. The
ACTIVE light will come on.
To turn it off, press it
again. When the DOOR
ALARM is active, the
ACTIVE light will flash if
you open the door and
beep if you keep the door
open for more than 2
minutes. The light goes
out and the beeping
stops when you close
the door.
Spill Shelf
Consumer
S
uppor
t
Tr
oubleshooting
Tips
Operating
Instructions
Safety
Instructions
Installation Instructions