Fisher & Paykel Ecosmart GWL11 - Manuel (Page 20)

20
Wash Cycles and Options
Water Levels
Auto Water Level
Your Ecosmart can automatically select the appropriate
water level for the load.
1. Place your clothes in the machine, and press Power.
2. Select wash cycle (select Auto water level if not
automatically selected)
3. Press START/PAUSE
During fill the machine will pause occasionally to sense
the water level. The machine will check if the water
level is correct by using a series of two different agitate
strokes. (This may take over a minute). If it detects that
the water level is not enough, it will fill with more water
and re-check the level.
When washing an unusual load eg. large bulky
garments, pillows, we recommend you manually
select the water level and select the Delicate cycle.
Manually select the water level if there is already water
in the machine.
For a large bulky load, or large single item (eg.
comforter) push the load down after the first fill.
Manual Water Level Selection
The agitator has five levels marked on its stem that can
be used to help you select the correct water levels.
Select the correct water level by using the mark nearest
to the top of the clothes.
The levels marked on the agitator do not correspond
exactly to the level of water. They indicate the level of
dry clothes suitable for the water level.
Your Ecosmart may occasionally add water during
agitation. This is to maintain the water level due to the
release of air trapped in the garments.
Out of balance loads, tangling or splashover can be
caused by selecting a water level that is too high.