A: make sure the product is on the network – HP Photosmart C4500 Manuel d'utilisation
Page 28
To check a wireless connection
1.
Make sure that the wireless radio on your computer is turned on.
2.
If you are not using a unique network name (SSID), then it is possible that your wireless computer
could be connected to a nearby network that is not yours. The following steps can help you
determine if your computer is connected to your network.
a. Depending on your operating system:
•
Windows XP: Click Start, point to Control Panel, point to Network Connections, and
then select View/Details.
OR
Windows XP: Click Start, point to Settings, point to Control Panel, point to Network
Connections, and then select View/Details.
•
Windows Vista: Click Start, point to Control Panel, point to Network Connections,
and then click View Network Status and Tasks.
Leave the network dialog box open while you continue to the next step.
b. Disconnect the power cord from the wireless router. The connection status of your computer
should change to Not Connected.
c. Reconnect the power cord to the wireless router. The connection status should change to
Connected.
If you are unable to get your computer connected to your network, contact the person who set up
your network or the router manufacturer as there might be a hardware issue with either your router
or computer.
If you are able to access the Internet, you can also access the HP Netw
or help in setting up a
network.
Step 2: Make sure that the HP All-in-One is connected to your network
If your product is not connected to the same network as your computer, you will not be able to use
the product over the network. Follow the steps described in this section to find out if your product is
actively connected to the correct network.
A: Make sure the product is on the network
▲
Print the product Network Configuration Page, then check the Network Status and URL.
To print the Network Configuration Page
a. Press the Wireless button on the product.
b. Press the button next to the down arrow on the display until Wireless Settings is
highlighted, and then press OK.
c. Press the button next to the down arrow on the display until Print Network Configuration
Page is highlighted, and then press OK.
This prints the Network Configuration Page.
Network Status
•
If the Network Status is Ready, the product is actively connected to
a network.
•
If the Network Status is Offline, the product is not connected to a
network. Run the Wireless Network Test (using the instructions at
the beginning of the Network Troubleshooting section) and follow
any recommendations.
URL
The URL shown here is the network address assigned to the product by
your router. You will need this address for step 2.
B: Check to see if you can access the HP Photosmart C4500 All-in-One series home
page
After you establish that the computer and the HP All-in-One both have active connections to a
network, you can verify if they are on the same network by accessing the HP Photosmart
Chapter 3
24
HP Photosmart C4500 All-in-One series
E
n
glish