Husqvarna 580 R - Manuel (Page 22)

GB - 22
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Engine will
not start 1. Fuel tank empty or low.
2. Spark plug wire loose or off.
3. Engine/brake control cable
detached, broken, or not
adjusted properly.
4. Battery discharged (electric
start models).
1. Check fuel level. Fill tank if
necessary.
2. Check connection.
3. Check engine/brake
control cable. Adjust,
repair or replace as
necessary.
4. Charge battery or replace
if necessary.
Self-propelled
drive does not
engage. 1. Traction drive bail not
engaged.
2. Drive belt out of position.
3. Drive belt worn or
damaged.
4. Rear wheels in different
cutting height positions.
5. Friction wheel engagement
not adjusted properly or
damaged.
6. Idler and idler spring
installed incorrectly.
7. Traction drive cable
detached or broken.
8. Bearings damaged.
9. Debris in gear set.
1. Engage traction drive bail.
2. Check drive belt. Adjust as
necessary.
3. Replace belt.
4. Adjust rear wheel cutting
position so that cutting
height is the same on both
sides.
5. Adjust or replace friction
wheel.
6. Check idler and spring.
Adjust as necessary.
7. Check drive cable. Adjust,
repair or replace as
required.
8. Replace bearings.Contact
your Dealer.
9. Remove debris. Contact
your Dealer.
ACCESSORIES
See your authorized Husqvarna dealer to
add these optional accessories.
606 00 00 01 Dethatcher
606 00 00 02 Swivel Wheel
606 00 02 30 Battery Charger