Husqvarna 580 R - Manuel (Page 19)

GB - 19
3. Charge for 24 to 48 hours (battery may
be charged for up to 72 hours with no
harmful effects).
An engine run time of at least 8 hours is
required to charge a fully discharged battery.
To Remove Battery from Unit
1. Remove wing nuts from battery U-bolt.
2. Disconnect battery from wiring.
ENGINE/BLADE CONTROL
To adjust engine/blade control:
1. Loosen cable nuts away from bracket.
2. Squeeze z-bend bracket at engine end
of cable toward front of unit and hold in
place.
3. Pull cable down from bracket until there
is no slack in cable.
4. Tighten lower
cable nut to 1/
8" (3mm)
below bracket.
Release z-
bend bracket.
5. Tighten upper
cable nut until
bracket is secure
between cable
nuts.
6. Engage engine/blade control. Measure
distance between middle of z-bend and
cable bracket. Measurement should be
as shown below.
7. If proper measurement cannot be
achieved, contact your local dealer.
Figure 16
Briggs & Stratton
Robin
No slack
1/8”
(3mm)
1.325"-1.788"
(3.4 - 4.5 cm)
Briggs & Stratton
1.240" (3.15 cm)
Robin