Honeywell 33 Inch Indoor Portable Evaporative Air Cooler Instruction Manual - Manuel (Page 4)

3
In cooling mode, Honeywell Air Coolers provide cool, moist air through
the evaporation of water. There is a manual Water Regulator knob located
in the ice compartment of the unit. This allows you to adjust the amount
of water pumped over the Honeycomb Cooling Media, thus helping to
control cooling and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a
minimal amount of water to the Honeycomb Cooling Media. This results
in less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water
to the Honeycomb Cooling Media. This results in maximum water evaporation and greater cooling
performance.
USE & OPERATION (CONTINUED)
EN
SWING
Press the SWING button until the SWING indicator light is illuminated on
the control panel. The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical
air flow.
COOL
Press the COOL button until the COOL indicator light is illuminated on the control panel. This
activates evaporative cooling. The water pump will operate and you will feel the cooler air after the
Honeycomb Cooling Media is completely wet. When the COOL indicator light is switched OFF, the
unit can still function in a fan only mode (without evaporative cooling).
FUNCTION BUTTONS (CONTINUED)
ROOM COOLING AND HUMIDIFYING
Water Regulator
MAX
MIN
Louver
Movement