Electrolux 736684 - Manuel (Page 19)

1 9
WEAR PROTECTIVE GLOVES WHEN
UNPACKING AND INSTALLING THE
APPLIANCE.
Read these instructions carefully before
carrying out installation. Installation and start-
up must be carried out by a qualified installer. If the installation
instructions for this product are not carried out by a qualified
service personnel (expert and competent in the installation of
commercial equipment) the manufacturer’s Warranty terms and
conditions shall be deemed void and no warranty shall be
applied.
IN CASE OF DOUBT, CONTACT YOUR LOCAL SERVICE
CENTER.
IMPORTANT:
The operations described below must be carried out in
compliance with current safety regulations, regarding the
equipment used and the operating procedures.
IMPORTANT: Before moving the appliance make sure that
the load-bearing capacity of the lifting equipment to be used
is suitable for its weight.
B.1.1 UNPACKING
B.1.1.1 Unpacking and handling
Cut the straps and remove the protective film, taking care not to
scratch the sheet metal if scissors or blades are used. Remove
the top part (cardboard), polystyrene corners and the vertical
protection. For appliances with stainless-steel cabinets, carefully
remove the protective film without tearing it, to avoid leaving glue
stuck to the surface.
Remove any traces of glue with a non-corrosive solvent, rinsing
and drying carefully. It is advisable to go over all the stainless-
steel surfaces with a cloth moistened with paraffin oil, in order to
create a protective film. Use a palletizer or fork-lift truck to lift the
equipment. Inserting the forks under the pallet, lift the appliance
and carry it to the place of installation, making sure the load is
balanced.
CAUTION:
Do not push or pull the appliance to move it, as it may tip over.
B.1.1.2 Disposal of packing materials
Packing materials must be disposed of in compliance with the
current regulations in the country where the appliance is used.
Recyclable plastic parts are marked as follows:
polythene:outer wrapping, instruction handbook bag
PE
polypropylene: straps
PP
polystyrene foam: corner pads
PS
press board: corner protection elements
B.1.2 POSITIONING
Install the equipment, taking all the safety
precautions required for this type of operation and
respecting the relevant fire-prevention instructions.
Install the appliance in a ventilated place, away from
heat sources such as radiators or air-conditioning
systems, to allow correct cooling of the cooling unit
assembly.
Never cover the condenser, even temporarily, as this
can compromise proper operation of the condenser
and therefore the equipment.
Make sure the position of the appliance allows easy door
opening.
Pay particular attention to leveling of the floor on which the
appliance stands, in order to ensure optimum operation.
If the appliance is installed in rooms where there are corrosive
substances (chlorine, etc.), it is advisable to go over all the
stainless steel surfaces with a cloth moistened with paraffin oil
in order to create a protective film.
The room temperature must not exceed 109.4°F/+43 °C in order
to maintain the recommended internal temperatures.
Adjust the height and leveling with the adjustment feet, also
checking correct door and drawer closing.
Note: The plug must be accessible even after positioning the
appliance in the place of installation.
IMPORTANT:
Level the appliance, otherwise its operation could be
compromised.
Adjust the height and leveling using the adjustment feet, also
checking door closing
For correct appliance operation it is advisable to respect the
distances given in the following picture
74.01"
7
4
.0
1
"
1880 mm1
8
8
0
m
m
26.38" 26
.38" 670 mm 670
mm
B.1 INSTALLATION