Roborock Empty Wash Fill Dock FCC - Manuel (Page 10)

11
Installation
Assembly
1. Place the dock on a hard and flat floor, and remove the foam
used to secure the high-speed maintenance brush components
in shipment at the bottom.
2. Attach the base by pressing down both sides of the base firmly,
and then pressing the connecting part in the middle until you
hear a click.
3. Connect the power cable to the back of the dock, and keep
excess cable inside the storage slot.
Note: Remove the water tanks and the dustbin before moving the dock.
Note: Power cable can exit at either side.
> 0.5 m (1.6 ft)
> 0.5 m (1.6 ft)
> 1 m (3.3 ft)
> 1.5 m (4.9 ft)
Placement of the Dock
Place the dock on a hard and flat floor (wood/tile/concrete etc.), flat
against a wall. Keep at least 0.5 m (1.6 ft) of clearance on either
side, 1.5 m (4.9 ft) in front, and 1 m (3.3 ft) above. Make sure the
location has good WiFi for a better experience with the mobile app,
and then plug it in.