DE DIETRICH DVI360 - Manuel (Page 19)

What to do before using the machine for the first time
Salt reservoir
Should any regenerating salt overflow when filling,
we recommend that you remove the loose salt crystals
to avoid oxidising the tub.
Never put deter-
gent in this reservoir:
this will ruin the water sof-
tener.
- Unscrew the salt reservoir’s stopper and
remove it.
- Use the funnel to introduce the salt.
- Fill the reservoir with regenerating salt
specially designed for dishwashers.
- On the first time, add water
until it reaches the edge
of the reservoir.
- Screw the salt reservoir’s stop
back in fully.
See Page 46-48 : symbol
indicating the level of regener-
ating salt:
After you have refilled the salt
reservoir, this symbol may still
flash until the salt has dissolved
sufficiently, generally after one
cycle (or if the reservoir has not
been completely filled, for instance
when putting the machine into
operation using the sample).
SEL
Do not use kitchen
salt.
If the water is especial-
ly soft and does not require
the use of any regenerating salt, the
SALT light remains lit.
Présentation de votre lave-vaisselle
35 34
GB GB
What to do before using the machine for the first time
STEP 1: Adjusting the water softener
For impeccable washing and drying results with no streaks.
The water softener must be adjusted correctly to ensure no streaks
after washing and drying.
Your dishwasher is fitted with a water softening system that operates
using regenerating salt.
You must set the water softener according to the hardness of the water
in your area.
Salt
required
Dureté d’eau > 70 °F
0 - 10°F
10 - 18°F
18 - 25°F
25 - 40°F
40 - 55°F
55 - 70°F
NO
YES
YES
YES
YES
YES
YES
Water softener
setting
Water
hardness
Testing strip
➁ ➁
- Settings on the control panel
Press the “SET” button
to set the water soften-
er: a long press to
access the “settings”
and 2 short presses for
the water softener. The
water softener’s setting
is then shown on the
display.
• Press the Programmes button to change the setting
• The setting is confirmed automatically after 10 seconds without having
to press the Programmes button again.
The display shows the water’s hardness in accordance with the above
table.
When the machine is first switched on, the setting is 10 - 25° (
on
the display).
Ca
Ca
Ca
Ca
Ca
Ca
Ca
Ca
You must fill the salt reservoir with water before
using the machine, even if the water softener setting
selected does not require any regenerating salt.
If you move house and take the dishwasher with you you will
need to check the water hardness and adjust accordingly.
For good wash results it is very important to set the dishwasher
to the correct level of water hardness and to set the correct
level of rinse aid (see page 36)
➀ ➀
- Measuring the water hardness
To do this: contact your local water supplier to find out the water
hardness level and adjust on the machine as described below.
③ ③ Filling the regenerating salt reservoir
You must fill this, with water just
before starting your first wash then
add the salt:
Filling with salt is essential to obtain a good
wash with no streaks. The salt regener-
ates the resins, which soften the water by
removing its limestone content unless the
water is already sufficiently soft (see
“Adjusting the water softener”).