Compliance and conformity, Connecteurs d'interface – TA Triumph-Adler P-C4580DN Manuel d'utilisation

Page 11

Advertising
background image

vii

Compliance and Conformity

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 and
Part 18 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• The use of a non-shielded interface cable with the referenced device is prohibited.

CAUTION

The changes or modifications not expressly approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

This device complies with Part 15 of FCC Rules and RSS-Gen of IC Rules.

Operation is subject to the following two conditions; (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.

* The above warning is valid only in the United States of America.

Connecteurs d'interface

IMPORTANT Assurez-vous que l'imprimante est hors tension avant de brancher ou de débrancher un câble d'inter-
face de l'imprimante. Pour protéger les composants électroniques figurant à l'intérieur de l'imprimante contre les dé-
charges d'électricité statique en provenance des connecteurs d'interface, recouvrez chaque connecteur d'interface
inutilisé avec le capuchon de protection fourni.

Canadian Department of Communications Compliance Statement

This Class B digital apparatus complies with Canadian ICES-003.

Avis de conformité aux normes du ministère des Communications du
Canada

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Remarque Utilisez des câbles d'interface blindés.

Advertising
Ce manuel est liée aux produits suivants: