DeVillbiss Air Power Company Simoniz S2600 - Manuel (Page 16)

16- ENG A08989
HOW TO DRAIN THE DUAL-
DETERGENT INJECTION TANKS
1. Turn detergent selection dial to
the down (off) position.
(See Fig. 25)
2. Remove cleaning solution hose
at detergent injection system
(see Fig. 26a) and pull through
rear shroud (see Fig. 26b).
3. Place end of cleaning solution
hose into a suitable container to
drain cleaning solution. (See Fig.
27)
4. Turn detergent selection dial
toward tank to be drained.
5. Repeat steps 3-4 to drain second
tank.
6. Turn detergent selection dial to
the down (off) position.
7. Fill tanks with clean water.
8. Turn detergent selection dial
toward tank and drain water from
tank. Repeat on second tank.
NOTE: This will rinse cleaning
solution tanks.
9. Feed cleaning solution hose
between shroud and wheel
bracket making sure it is routed
over the axle as shown in Fig.
28a and 28b. Reconnect cleaning
solution hose to detergent/
cleaning solution injector for
future use.
Axle
Hose
Fig. 27
Fig. 28a
Fig. 28b
Detergent selection dial
Fig. 25
Fig. 26a
Fig. 26b
PRESSURE WASHER
1. Drain all water from high
pressure hose, coil it, and store
it in cradle of the pressure
washer handle.
2. Drain all water from spray gun
and wand by holding spray gun
in a vertical position with nozzle
end pointing down and squeez-
ing trigger.