DeVillbiss Air Power Company Simoniz S2600 - Manuel (Page 15)

15- ENG A08989
HOW TO CLEAN THE WATER
INLET FILTER
This screen filter should be checked
periodically and cleaned if necessary.
1. Remove
filter by
grasping
end and
removing it
from water
inlet of pump
as shown in Fig. 23.
Filter Screen
1. Obtain a funnel , 6 oz. of RV*
antifreeze, and 16–36" of garden
hose with a male hose connector
attached to one end.
Use only RV
antifreeze. Any
other antifreeze is corrosive and
can damage pump.
STORAGE
ENGINE
Consult the Engine Owner's
Manual for the manufacturer's
recommendations for storage.
2. Disconnect spark plug wire.
3. Connect a hose to water supply
inlet of pump.
4. Add RV* antifreeze to hose as
shown in Fig. 24.
5. Pull engine starter rope slowly
several times until antifreeze
comes out of high pressure hose
connection of pump.
6. Remove hose from water supply
inlet.
7. Reconnect spark plug wire.
*Windshield washer fluid may also be
used
PUMP
The manufacturer recommends using
a pump protector/winterizer when
storing the unit for more than 30 days
and/or when freezing temperatures
are expected. If a pump protector/
winterizer is not available, RV*
antifreeze needs to be run through the
pump as outlined in the steps below.
NOTE: Using a pump protector/
winterizer or RV* antifreeze is to
provide proper lubrication to the
internal seals of the pump regardless
of temperature or environment.
Fig. 23
Fig. 24
2. Clean filter by flushing it with
water on both sides.
3. Re-insert filter into water inlet
of pump. NOTE: Cone side faces
out.
NOTE: Do not operate pressure
washer without filter properly installed.