Washer maintenance, Manually add fabric softener to dispenser, Press start/pause to begin wash cycle – Maytag NTW4615EW Manuel d'utilisation

Page 9

Advertising
background image

9

9.

Manually add fabric softener to

dispenser

During the final rinse, wait until the washer has completed

filling, press the START/Pause button to pause the

washer. Lift the lid and add the measured recommended

amount of liquid fabric softener. Do not use more than the

recommended amount. Close the lid and press the START/

Pause button again to start the washer.

8.

Press START/Pause to begin

wash cycle

Press the START/Pause/Unlock Lid button to start the wash

cycle. When the cycle has finished, the CYCLE COMPLETE

indicator will light. Promptly remove items after cycle has

completed to avoid odor, reduce wrinkling, and rusting of

metal hooks, zippers, and snaps.

Adding garment(s)

During the Fill/Sensing phase, open lid and add 1 or 2 missed

garments. Then close lid and press START/Pause/Unlock

Lid to restart the cycle. If you need to open the lid to add

a garment after this point, you must press START/Pause/

Unlock Lid and wait for the lid to unlock. This may take

several minutes if the load was spinning at a high speed. You

may hear a winding sound as the basket slows down. Then

add garment, close lid, and press START/Pause/Unlock Lid

again to resume the cycle.
NOTES:

Washer will fill with the lid open.

If your washer does not have a soak option, then pause

your washer to soak. When you are done soaking then

press Start/Pause button to bring washer out of Pause.

IMPORTANT: If lid is left open for more than 10 minutes, the

water will pump out automatically.


WASHER CARE

Recommendations to Help Keep Your Washer Clean and

Performing at its Best
1.
Always follow the detergent manufacturer’s instructions

regarding the amount of detergent to use. Never use more

than the recommended amount because that may increase

the rate at which detergent and soil residue accumulate

inside your washer, which in turn may result in undesirable

odor.

2. Use warm and hot wash water settings sometimes (not

exclusively cold water washes), because they do a better

job of controlling the rate at which soils and detergent

accumulate.

3. Always leave the washer lid open between uses to help dry

out the washer and prevent the buildup of odor-causing

residue.

Cleaning Your Top Loading Washer
Read these instructions completely before beginning the

routine cleaning processes recommended below. This Washer

Maintenance Procedure should be performed, at a minimum,

once per month or every 30 wash cycles, whichever occurs

sooner, to control the rate at which soils and detergent may

otherwise accumulate in your washer.
Cleaning the Inside of the Washer
To keep your washer odor-free, follow the usage instructions

provided above, and use this recommended monthly cleaning

procedure:
Recommended Cycle for Cleaning the Washer
Refer to the “Cycle Guide” for the optimal cycle for cleaning

the inside of the washer. Use this cycle with affresh

®

Washer

Cleaner or liquid chlorine bleach as described below.
Begin procedure
1.
affresh

®

Washer Cleaner Cycle Procedure (Recommended

for Best Performance):

a. Open the washer lid and remove any clothing or items.
b. Place an affresh

®

Washer Cleaner tablet in the bottom of

the washer basket.

c. Do not place an affresh

®

Washer Cleaner tablet in the

detergent dispenser.

d. Do not add any detergent or other chemical to the washer

when following this procedure.

e. Close the washer lid.
f. Select the cycle recommended for cleaning the inside

of the washer.

g. Press the START/Pause button to start the cycle.

NOTE: For best results, do not interrupt cycle. If cycle must

be interrupted, press START/Pause once. After the cycle

has stopped, run a RINSE & SPIN cycle to rinse cleaner

from washer.

Replace inlet hoses after 5 years of use to reduce the risk of

hose failure. Periodically inspect and replace inlet hoses if

bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses, mark the date of replacement

on the label with a permanent marker.
NOTE: This washer does not include inlet hoses. See the

“Installation Instructions” for more information.

WATER INLET HOSES

Washer Maintenance

Advertising