Maytag MGD8100DC - Manuel (Page 7)

7
Steam Boost
Steam Boost adds steam to the end of the Heavy Duty, Bed-
ding, or Normal cycle to help smooth wrinkles. Steam Boost can
be used with High or Medium heat settings. This option adds
approximately 15 minutes to the total cycle time.
Cycle Signal
Use this to turn the signal indicating the end of a drying cycle on
or off.
NOTE: You may also turn off the tones that sound when
a feature, setting, or option is touched. Touch and hold Cycle
Signal for about one second to turn sounds on
or off.
Control Lock
Use to lock the controls of the dryer and avoid
an accidental change in cycle options or preferences during a
drying cycle.
Touch and hold CONTROL LOCK for 3 seconds to lock or
unlock the controls of the dryer. During this time, the LED
Display will count down 3-2-1. Once the controls
are locked, the LED Display will display “Lc” or “Loc.”
NOTE: The Control Lock function may be enabled when
recovering from a power failure. To unlock the control, touch and
hold CONTROL LOCK for at least 3 seconds.
CYCLE STATUS INDICATORS
The Cycle Status Indicators show the progress of a cycle. Not all
indicators are available on all models.
Sensing
The Sensing indicator will light during Sensor Cycles to
indicate that the moisture sensor on the dryer is operating. This
indicator will not light during Timed Cycles or options such as
Wrinkle Prevent.
Check Vent
This indicator will show the status of airflow through the dryer
and the dryer vent system for the dryer’s life. During the sensing
phase at the beginning of the cycle, the Check Vent light will
come on if a blocked vent or low airflow issue is detected. This
light will stay on for the entire cycle. The light will be cleared
when selecting a new cycle, touching POWER, or opening the
door after the cycle has completed. This feature is available
during Sensor and Steam cycles only. For more information
on maintaining good airflow, see “Check Your Vent System for
Good Airflow”.
NOTE: If there are other error issues during a cycle, the Check
Vent indicator will not light up. See “Troubleshooting” section.
Good Airflow
This indicator will light if there is no major vent blockage.
Steaming
This indicator will light when a steam function is active.
NOTE: Steam is not available on all cycles.
Done
This will indicate that the selected cycle has ended and the load
may be removed from the dryer. If Wrinkle Prevent has been
selected, the dryer may continue to tumble the load, even if
the Done indicator is lit.
Check Lint Screen
The Check Lint Screen indicator will light when the drying
cycle is complete as a reminder to clean the lint screen.
Appearance may vary.
6