Maytag MVWC215EW - Manuel (Page 5)

5
LID LOCKED
The Lid Lock feature allows for higher spin
speeds. When the Lid Locked light is lit, the
lid is locked and cannot be opened without
pausing the cycle.When the Lid Locked light
is off, the lid can be opened.
To open the lid after it has been
locked, press START/Pause. The
lid will unlock once the washer
movement has stopped. This may
take several minutes if the load
was spinning at high speed. Press START/Pause while
the lid is closed to resume the cycle.
SENSING FILL
When the START/Pause button is pressed, the washer
will fill to an initial water level and begin sensing to
determine the load size. The washer will then continue
filling to the appropirate water level based on load size
and proceed to Wash.
If the lid is opened or the START/Pause button is
pressed, the cycle will pause. Closing the lid and/
or pressing the START/Pause button will resume the
cycle. If the cycle remains paused with the lid open for
10 minutes, the washer will pump out the water.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle.
Wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the
washer rinses and moves the load. You may hear
the motor turning on briefly (short hum) to move the
basket while filling.
SPIN
The washer spins the load at increasing speeds for
proper water removal based on the selected cycle.
DONE
Once the cycle is complete, this light will come on.
For best results, remove the load promptly.