Danby DWC458BLS - Manuel (Page 8)

TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
1) No Power.
2) Cabinet Temperature too
high.
3) “Clicking” noise.
4) Condensation on the
cabinet and/or doors.
• A fuse in your home may be
broken or a circuit breaker
tripped.
• Power surge.
• Plug not fully inserted into wall
outlet.
• Temperature set too high.
• Door(s) not shut properly, or
opened excessively.
• Recently added a large quantity
of warm bottles to the cabinet.
• This audible ‘clicking’noise
may be heard as the wine cooler
ends or begins a cooling cycle.
• High humidity conditions in the
home.
• Door(s) not shut properly, or
opened excessively.
• Replace fuse or reset circuit
breaker.
• Unplug the wine cooler, wait a
few seconds, then plug it back in.
• Make sure the 3-prong plug on
the wine cooler is fully inserted
into the outlet.
• Verify the temperature control
setting; adjust if necessary.
• Ensure that the doors are fully
closed and that the gaskets are
sealing against the cabinets. Open
the doors only as needed and for
short periods of time.
• Limit the quantity of warm
bottles introduced at one time.
Attempt to phase in the load
introduction if possible.
• No user intervention necessary;
this sound is normal.
The condensation will subside
once humidity conditions return to
normal.
• Ensure that the doors are fully
closed and that the gaskets are
sealing against the cabinets. Open
the doors only as needed and for
short periods of time.
7