Velodyne vLeve - Manuel (Page 4)

How to connect
To connect your vLeve headphones, plug the 3.5 mm (1/8”) connector with the blue marker into the left
ear cup.
Plug the right-angle 3.5 mm (1/8”) connector into the audio output port on your audio device.
Wearing vLeve headphones
Located above the inside of each ear cup are markings for right and left audio channels.
Wear the ear cup marked “Right” over your right ear and the one marked “Left” over your left ear.
Always turn down the volume on your audio equipment before wearing vLeve headphones. Once the ear
cups are comfortably seated over your ears, gradually increase the volume to a moderate sound level.
Cleaning
Ear cups should be cleaned regularly for sanitary reasons and to prolong the life of your ear cups.
Wipe using a clean soft cloth or microfiber towel. Do NOT use alcohol or sanitizer on the matte painted
headphones as damage can occur.
Adjusting the headband
The headband on the vLeve is adjustable to fit different head sizes.
Hold the headband and adjust by pulling on the right and left ear cups.
The right and left ear cups should be centered over the ears.
Fold your headphones
vLeve headphones can fold for easier storage. To fold, remove any cables attached to the headphone
and push each ear cup inward towards the inside of the band.
Do not get the speakers or electronics inside of your headphones
wet. Liquids and heavy moisture can cause damage to the
electronics inside your headphones. Such accidental damages
are not covered under warranty.
3
vLeve user guide