Labconco Protector Premier Laboratory Hoods 10080 Series - Manuel (Page 36)

Chapter 7: Modifying Your Protector Premier
Product Service 1-800-522-7658 32
Original instructions
Installing Ceiling Enclosures Above the
Fume Hood
Your Protector Fume Hood has mounting holes to accept a ceiling enclosure to
close off the area between the top of the hood and the ceiling. Contact Labconco
Customer Service for ordering information.
Figure 7-2
Installing Rear Panels Behind the Fume
Hood
Your Protector Fume Hood can be modified to add a rear panel behind the fume
hood when the fume hood is placed on an island (not available on Pass-Through
Fume Hood). Contact Labconco Customer Service for ordering information.
Installing Additional Service Fixtures
Additional service fixtures can be installed in the available service fixture holes in
both sidewalls and corner posts. The fume hood is factory set to accept up to four
valves per side. Contact Labconco Customer Service for information.
Figure 7-5 – Hose Connector Figure 7-3 - Knob Figure 7-4 - Valve