DCS DD-30SS - Manuel (Page 11)

10
INSTALLING DOWNDRAFT (continued)
the downdraft. The square metal frame must be attached to the mouth of the blower. The exhaust
knockout on the rear must be removed. A metal plate and two screws are supplied in the hardware
package to cover the unused exhaust exit.
CAUTION:
Make sure that the wiring cable connecting the blower to the field wiring
compartment remains securely attached under the two cable clamps.
7) Attach the Backdraft Damper.
8) Remove the field wiring compartment cover and determine which direction the wiring will run
from the appliance to the wiring box and remove the wiring knockout.
9) Insert the downdraft unit into the countertop cutout. Make sure that the unit is firmly placed at
the rear of the cutout. Fasten the legs to the cabinet floor using the two longer Phillips head
screws supplied in the hardware package.
WARNING :
When attaching the Under Counter Mounting Brackets:
DO NOT drill into the countertop surface.
Check that the mounting screws are the proper length and will not extend
through the countertop surface when tightened. Failure to follow these
warnings could result in damage to the countertop surface.
10) Attach the downdraft to the countertop using the undercounter mounting brackets (Fig. 08). This
system is designed to adjust to different countertop thicknesses. Using the small Phillips head
machine screws in the hardware package, attach one undercounter mounting bracket to the slot
on the upper right corner of the unit. Attach the other end of the bracket to the underside of the
countertop.
11) Thread the power supply cable through the wiring knockout into the field wiring compartment.
Connect the three white wires
together with a twist-on wire
connector.
Connect the two
black wires with a twist-on wire
connector. Attach the
Green (or
Green and Yellow) ground wire
to the eyelet with the
green
grounding screw. Replace the
field wiring compartment cover.
12) Turn the power supply on. Push
and hold the Up/Down button
momentarily. The downdraft will
rise out of the countertop and
stop in the fully extended
position. Position the top strip
over the the top of the
downdraft, lining up the fixing
hooks and the hole for the push
button. Snap into place. Turn the blower on. The blower control switch is located on the right
hand side of the plenum as indicated in Fig. 11. If the blower does not work, refer to section
entitled "If The Blower Does Not Operate" located on page 11"
Wiring Box Cover
Knock-out
Grounding
Screw Wiring
Box
Up/Down
Button
Blower Control
Switch
INSTALLATION INSTRUCTIONS
FIG.11