Danby DAC100EB2GDB - Manuel (Page 13)

Operating Instructions
USING THE REMOTE
CONTROLLER
BUTTONS
1
2
3
AUTO OPERATION
Ensure the unit is plugged in and power is
available.
1) Press the ON/OFF button to start the air
conditioner.
2) Press the mode button and select
AUTO.
NOTE
1. In the Auto mode, the air conditioner can logically choose the mode of
Cool, Fan, Dehumidifying by sensing the difference between the
actual ambient room temperature and the set temperature on the
remote controller.
2. In the Auto mode, you cannot change the fan speed. It has already been
automatically controlled.
3. If the Auto mode is not comfortable for you, the desired mode can be
selected manually.
3
1
2
3
4
COOLING / FAN OPERATION
Ensure the unit is plugged in and power is
available.
1) Press the ON/OFF button to start the air
conditioner.
2) Press the MODE button to select Cool mode.
4) Press the FAN button to select the fan
NOTE:
In the Fan mode, the setting temperature is not displayed in the remote
controller and you are not able to control the room temperature either. In
this case, only step 1, 2 and 4 may be performed.
1 2
DEHUMIDIFYING OPERATION
Ensure the unit is plugged in and power is
available.
1) Press the ON/OFF button to start the air
conditioner.
2) Press the MODE button to select
NOTE:
In the Dehumidifying mode, you cannot change the fan speed. It has
already been automatically controlled.
10
speed
AUTO. in four steps-Low, Med, High,or
Dehumidifying mode.
3) Press the TEMP / button to
set the desired temperature. The
temperature can be set within a range of
17°C to 30°C in 1°C increments.
3) Press the TEMP / button to
set the desired temperature. The
temperature can be set within a range of
17°C to 30°C in 1°C increments.
3