Deni 7600 - Manuel (Page 5)

4
seconds and the red indicator light will illuminate. The
clock will begin to count down.
4. When setting the time to 0, the electric timer will return
to the clock mode automatically. The maximum steaming
time is 90 minutes.
5. When steaming, press the +/- button to change the set
time. Press the On/Off to stop the steam process. The
display will return back to clock mode.
Timing The Steam Mode:
1. Press the “Program” button. “Prog” will appear on the
upper left of the display.
2. Set the time by pressing the +/- button. The time will
increase and decrease in 10 minute intervals.
3. Press the “Program” button until the display shows 45.
Press the +/- button to adjust the steaming time.
4. Press the “Program” button again. The display will show
the time and “Prog”. This indicates the start of the timing
steam mode.
5. When the start time is reached, the unit will sound, the
red indictor light will illuminate and the steamer will
begin to steam.
6. If you want to cancel the timing steam mode, press the
“Program” button. This will return the unit back to the
clock mode.
At the end of steaming:
1. The steamer will automatically go into a hold mode after
the steaming time is finished.
2. The display will show the time and a holding symbol in
the lower left corner. The green indicator light will
illuminate.
3. The hold mode will warm for 2 minutes every 8 minutes,
after the unit stops steaming.
4. To cancel the hold mode, press the On/Off button. The
display will return to the clock mode.