Vicks Waterless Vaporizer V1900N-CAN - Manuel (Page 3)

Care and Cleaning
CAUTION:
ALWAYS DISCONNECT THE PLUG FROM THE ELECTRICAL OUTLET AND LET
THE WATERLESS VAPORIZER COOL DOWN FOR AT LEAST 20 MINUTES BEFORE CLEANING.
After Each Use
1. Open Lid and wipe the scent tray dry with a clean cloth or paper towel.
2. Store in a cool dry place.
3. Do not submerge in water or use other materials to clean the unit.
Vicks Scent Pads
Vicks Scent pads have been designed to work with your Waterless Vaporizer to provide
soothing menthol and eucalyptus vapors. Vicks Scent pads are available where the Vicks
Waterless Vaporizers are sold.
Using Your Vicks Waterless Vaporizer
Read all instructions before using this appliance.
Use Vicks Menthol Vapor Pads with your (or other model). Each pad is specifically designed
to work with the heat of the Vicks Waterless Vaporizer to gradually release soothing aromatic
vapors.
Directions:
1. Fully unravel cord. Failure to do so could cause overheating and possible fire hazard. Do
not use with extension cords. Place waterless vaporizer on a flat, stable surface for use.
2. Open the lid of the Vicks Waterless Vaporizer
3. Place one scent pad over the heat vents.
4. Lower lid and press down firmly to lock.
5. Turn the unit on using the switch.
6. Adjust to desired setting for desired scent release.
7. Each pad is designed for single use and will last from 4 - 8 hours depending on heat.
Waterless Vaporizer will feel warm to the touch. Be careful when handling.
When vapor therapy treatment is completed, move On/Off switch to the Off position. The lamp
will go out. Disconnect plug from electrical outlet. Allow the Waterless vaporizer to cool before
moving or replacing the pad it (see Care and Cleaning section).