Panasonic CQ-DP745 - Manuel (Page 20)

Installation Guide
A WARNING
The installation information is designed for experienced installers and is not
intended for non-technical individuals. It does not contain warnings or cautions of
potential dangers in attempting to install this product.
Any attempt to install this product in a motor vehicle by anyone other than quali­
fied installer could cause damage to the electrical system and could result in seri­
ous personal injury or death.
□ Overview
This equipment should be installed by a profes­
sional. However, if you plan to install this unit
yourself, your first step is to decide where to
install it. The instructions in these pages will
guide you through the remaining steps: (Please
refer to “WARNING” statement above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
• Check the operation of the unit
If you do encounter problems, please consult
your nearest professional installer.
Caution: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so
could cause serious damage.
* •
Before you begin installation, look for the follow­
ing items included in the packing with your unit.
• Warranty Card .... Fill this out promptly
• MSC (in Canada: Panasonic) Servlcenter
Directory .......Keep for future reference in case
the unit needs servicing
• instailation Hardware ......... Needed for in-dash
installation
□ Installation Hardware
No. item Diagram Qty
©
Mounting Collar 1
@ Plain Washer (5 mmif)) 2
@
Spring Washer (5 mm<t)) 2
©
Hex. Nut (5 mm<(i)
®
2
CD
Rear Support Strap 1
®
Hex. Bolt
(5 mm(t> X 25 mm) (/
1
Toothed Lock Washer
(5 mm<t))
©
1
Mounting Bolt (5 mmtf)) 1
Power Connector 1
Removable Face Plate
Case
1
Remote Control Unit 1
Lithium battery
©
1
20
CQ-DP745i730EUC