Panasonic Cassette Receiver with CD Changer Control CQ-R545 - Manuel (Page 19)

Installation Guide
A
WARNING
This installation information is designed for experienced installers
and is not intended for non-technical individuals. It does not contain
warnings or cautions of potential dangers in attempting to install
this product.
Any attempt to install this product in a motor vehicle by anyone
other than qualified installer could cause damage to the electrical
system and could result in serious personal injury or death.
□ Overview
This equipment should be installed by a profession­
al. However, if you plan to install this unit yourself,
your first step is to decide where to install it. The in­
structions in these pages will guide you through the
remaining steps: (Please refer to “WARNING” state­
ment above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
• Check the operation of the unit
If you do encounter problems, please consult your
nearest professional installer.
CAUTION: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not at­
tempt to use it in any other system. Doing so could
cause serious damage.
Before you begin installation, look for the following
items included in the packing with your unit.
• Warranty Card..... Fill this out promptly
• MSC (in Canada: Panasonic) Servicenter Di­
rectory ..... Keep for future reference in case the
unit needs servicing
• Installation Hardware....... Needed for in-dash
installation
□ Installation Hardware
No. Item Diagram Qty
©
Mounting Collar
%
1
©
Plain Washer (5 mm(}>) 2
©
Spring Washer (5 mmij)) 2
©
Hex. Nut (5 mmtt)) 2
Rear Support Strap 1
©
Hex. Bolt
(5
mmif) X 25 mm)
1
Toothed Lock Washer
(5 mm())) %
1
Mounting Bolt (5 mmcj)) 1
Power Connector
0
1
Removable Face Plate
Case (Only for CQ-
R545/R525EUC)
1
CQ-R545/R525/R520EUC
19