Panasonic Removable Face High-Power /Receiver DPX30EUC - Manuel (Page 18)

Installation Guide
A
WARNING
The installation information is designed for experienced installers and is not
intended for non-technical individuals. It does not contain warnings or cautions of
potential dangers in attempting to install this product.
Any attempt to install this product in a motor vehicle by anyone other than
qualified installer could cause damage to the electrical system and could result in
serious personal injury or death.
□ Overview
This equipment should be installed by a
professional. However, if you plan to install this
unit yourself, your first step is to decide where to
install it. The instructions in these pages will
guide you through the remaining steps: (Please
refer to “WARNING” statement above).
• Identify and label the vehicle wires
• Connect the vehicle wires to the wires of the
power connector
• Install the unit in the dash
• Check the operation of the unit
If you do encounter problems, please consult
your nearest professional installer.
Caution: This unit will operate with a 12 volt DC
negative ground auto battery system only. Do not
attempt to use it in any other system. Doing so
could cause serious damage.
Before you begin installation, look for the
following items included in the packing with your
unit.
• Warranty Card .... Fill this out promptly
• MSC (in Canada: Panasonic) Servicenter
Directory..... Keep for future reference in case
the unit needs servicing
• Instailation Hardware......Needed for in-dash
installation
□ Installation Hardware
No. Item Diagram Qty
©
Mounting Collar 1
Plain Washer (5 mm^) 2
Spring Washer (5 mmtt)) 2
Hex. Nut (5 mm(|)) 2
© Rear Support Strap 1
Hex. Bolt
(5 mmift X 25 mm)
1
Toothed Lock Washer
(5 mm(|))
%
1
Mounting Bolt (5 mm({))
0
1
Power Connector
#
1
Removable Face Plate
Case
1
©
Remote Control Unit
(Only for CQ-DPX50EUC) <#
1
(g) Lithium battery
(Only for CQ-DPX50EUC) ©
1
Dismounting Plate 1
18
CQ-DPX50/DPX30EUC