Synchronization setting (sync), Sync – Panasonic WV-BL730 Manuel d'utilisation
Page 28
Attention! Le texte de ce document a été détectée automatiquement. Pour consulter le document original, vous pouvez utiliser le mode "Original".

6. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). Additionally, this model accepts VS signal
(B/W composite video or composite sync signal). The
VD2 signal (multiplexed vertical drive signal) with the
composite video output signal from external equipment
such as a Matrix Switcher is also acceptable.
Whenever the VD2 signal is supplied to this camera,
the camera automatically switches to the VD2 sync
mode.
1. Move the cursor to the SYNC parameter and
select line-lock(LL) or internal (INT).
2. Press El.
If LL is selected, the SYNC menu appears. (If INT
is selected, the synchronization mode is automati
cally set to internal sync pulse, and the menu is
not.dispiayed.)
** СЛМ SET UP
**
CAMERA ID
OFF
П
ALC/EIX:
AbC
n
SHUTTER
OFF
AGC
OH
SENS UP
OFF
SYNC
MOTION DET
OFF
"1
LENS DRIVE DC
END
SET UP ENABLE
-
26
-
Important Notices:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest pri
ority)
2. Line-lock (LL)
3. B/W Composite Video or Composite Sync
Signal (VS)
4. Internal Sync (INT) (Lowest priority)
2. When the internal sync mode is to be used, select
INT. No gen-lock input signal should be supplied
to the Gen-lock Input Connector on the rear panel.
3. Whenever the multiplexed vertical drive pulse
(VD2) is supplied to the camera from an external
equipment such as a Matrix Switcher, the camera
sync mode is automatically switched to the VD2
mode.
4. When the VS gen-lock mode is to be used select
INT from this menu and supply the gen-lock input
/ signal to the Gen-lock Input Connector on the rear
panel.
5. The VS gen-lock mode has its own menu for hori
zontal phase adjustments. When the cable length
of the^ video output or the gen-lock input is
changed, the horizontal phase must be re-adjust
ed.
6. The line-lock mode has its own menu for line-lock
vertical phase adjustment. If the camera installa
tion is relocated, check the vertical phase adjust
ment again since the AC line phase may be differ
ent.