Panasonic NI-L70SR - Manuel (Page 3)

7. Close supervision is necessary for any appliance being used by or near children.
Do not leave iron unattended while connected to an electrical outlet or on an
ironing board. Always position iron carefully to prevent it from falling if ironing
board is accidentally bumped or if Cord is pulled. When not in use, always place
iron securely into Power Base.
8. Burns can occur from touching hot metal parts, the hot surface of the Power Base,
hot water, or steam. Use caution when you turn a steam iron upside down-there
may be hot water in the Water Tank.
9. To protect against burns or injury to persons, do not direct steam toward the
body when ironing or self-cleaning.
10. The iron must be used and rested on a stable surface. When placing the iron into
Power Base, ensure that the surface on which the Power Base is placed is stable.
11. The AC Power Cord and Plug may present
a risk of personal injury when the cord is
allowed to retract freely. Always hold the
plug and cord with one hand while it is O pullout 5 - 1 0 cm
retracting, and retract the cord slowly to
reduce the risk of the cord "WHIPPING",
which has the potential risk of causing
injury to the face, eyes, etc..
SPECIAL INSTRUCTIONS
AWARNING To reduce the risk of electric
shock or fire:
1
. Do not operate another high wattage appliance in the same circuit, to avoid a
circuit overload.
2. If an extension cord is absolutely necessary, use a cord rated a minimum of 13
amperes.
Cords rated for less amperage may overheat, and should not be used.
Care should be taken to arrange the cord so that it cannot be accidentally
pulled or tripped over.
A CAUTION
To reduce the risk of personal
injury and damage to your iron:
1. Never use steam iron cleaning products in the iron, as they may damage working
parts of the iron.
2. Do not use water additives or substitute water such as linen or scented water in
the steam iron. They can stain fabrics.
3. If the Steam/Dry Selector is not at Dry position after using, remaining water will
move into the Soleplate and can result in burns when you next use the iron.
4. Don’t use the Steam or Jet of Steam, while AC Power Cord is unplugged. Water
will remain inside the soleplate which will cause staining.
Please do not use Steam or Jet of Steam while Temperature Control Pad is set
to "OFF". _
3
_