Led boards, Removing the left led board, Replacing the left led board – Dell Latitude E4200 (Late 2008) Manuel d'utilisation
Page 32
Back to Contents Page
LED Boards
Dell™ Latitude™ E4200 Service Manual
Removing the Left LED Board
1.
Follow the procedures in
Before Working on Your Computer
.
2.
Remove the LED cover (see
Removing the LED Cover
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Remove the M2 x 3-mm screw on the left side of the LED board.
5.
Slide the LED board towards the front of the computer to release it from the tabs on the palm rest.
6.
Disconnect the cable to the system board by gently pulling up on the release latch.
Replacing the Left LED Board
1.
Holding the LED board with the cable on the upper right side, slide the back edge of the board under the tabs on the palm rest.
2.
Connect the cable to the system board by gently pressing on the release latch.
3.
Replace the M2 x 3-mm screw on the left side of the LED board.
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
1 screw 2 left LED board
3 tabs
4 palm rest
5 cable 6 release latch
CAUTION:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage on www.dell.com at: www.dell.com/regulatory_compliance.
NOTICE:
Before installing the LED cover, ensure that all cables are routed correctly. Improper routing of the cables can cause damage to the cables.