Aerus Lux 2000 - Manuel (Page 4)

4
CAUTION:
Turn the cleaner OFF before connecting
or disconnecting wands, power nozzle and hose.
To install power hose,
align arrows on hose (A)
with those on the suction
end of cleaner. Insert hose
until it clicks.
To remove power hose,
press release tab (B) and
pull hose out.
Note: Before assembling
wand (E), check that the
electric cord connector (C)
at end of sheath is properly
positioned in its receptacle
(D).
To assemble wand, insert
the lower wand, large end
first (E), into sheath (F) until
latch (G) engages.
To disassemble wand, slide
release button (H) forward
and pull lower wand from
sheath.
To connect hose handgrip
(I) to the sheath wand (J),
align electrical connections
on underside of sheath
wand and hose handgrip,
and insert until latch clicks.
To remove hose handgrip
(I), press latch (K) and pull
handgrip out.
To attach power nozzle (L),
slide end of wand (M) into
elbow (N) on nozzle. Plug
cord (O) on power nozzle
into connector in sheath(F).
To disassemble power
nozzle (L), unplug cord,
press release button (P) and
pull wand (M) out.
To assemble accessory
wands (Q),insert the narrow
end of the wand into the
large end of the second
wand.
To attach accessory wand
to hose handgrip (R), insert
the hose handle into the
large end of the wand.
O
P
M
N
L
The motor of this cleaner shuts off when the temperature
rises above the proper operating level. This prevents damage
from overheating, and prolongs the life of the motor.
If the cleaner shuts off automatically due to overheating
protection:
• Depress the ON/OFF toe switch (S) and disconnect
power cord.
• Check the wands, hose, power nozzle, filter bag and afterfil-
ter for blockage.
• Replace the filter bag if it is full of debris or it has been used
to vacuum up fine particles, such as talculm powder or
sheetrock dust, which will prematurely clog the bag.
• With the power cord disconnected from outlet, allow the
machine to cool for a minimum of 30 minutes before using
again.
• After the 30 minute cool down period, plug power cord in,
turn cleaner ON and resume cleaning.
K
OVERHEATING PROTECTION
S
B
Release Tab
A
Alignment
Mark
C
D
H
G
E
F
I
J
Q
R
ASSEMBLING THE HOSE, WANDS, AND POWER NOZZLE