Aerus Lux Guardian Upright - Manuel (Page 8)

8 8
WARNING : Electric shock could occur if used
outdoors or on wet surfaces. Do not operate your
cleaner in the presence of explosive or flammable
material or fumes.
Plug cord into a standard 120 V A.C. outlet. Be sure unit switch is
in the OFF position.
The control switch has three positions: 0FF (O),
FLOOR (I), and CARPET (II).
O Always set the switch to OFF (0) when the cleaner is not
in use.
I Set the switch to FLOOR (I) to stop the rotating brush,
using the powerful air flow alone to clean hard floors,
delicate oriental, Russian, or antique rugs and for above-
the-floor cleaning.
II Set the switch to CARPET (II) for deep cleaning rugs
and carpets.
The cleaner automatically locks in the upright position.
(Note: When the cleaner is locked in the upright position, the
brush will not rotate with the switch set to carpet(II).)To
release the handle, place foot lightly on the base of the
machine and gently pull operating handle backwards. Once
the lock is disengaged, the handle will move up and down
freely as you clean.
If the brush does not rotate when switch is set to CARPET (II)
and lock is disengaged, press the RESET button (F) located on
the base of the cleaner.
Do not pull on cord to unplug unit. Carefully grasp plug and
pull from outlet.
The upright position should be used when carrying or storing
the cleaner. Your cleaner will roll easily from room to room,
over carpets and sills, when you lock the handle and tilt the
machine onto its rear wheels. G
F
E
D
BASIC OPERATION
Reset
D E
F G