Aerus Lux Guardian Upright - Manuel (Page 6)

6
The operating handle of your new Lux® Guardian can
easily be attached to your cleaner as follows:
CAUTION:
Be sure unit is NOT plugged in
before assembling handle.
• Locate the handle assembly . Remove the mounting screw
and nut plate from the handle.
• Open the cleaner bag compartment lid, remove the filter bag.
Place the nut plate into the pocket inside the bag
compartment as shown.
• Fit the end of the handle into the handle receptacle
IMPORTANT: Press down firmly when plugging handle into the
receptacle.
• Hold the handle against the bag compartment, attach the carry
handle and thread the mounting screw through the
handles into the nut plate.
• Tighten the mounting screw securely using a screwdriver.
NOTE: The handle must be properly inserted into the
receptacle for the screw to engage the nut plate(2).
• The accessory plug is an electrical connection for
powered accessories such as the Sidekick®.
• Attach HEPA Filter per header card instructions.
NOTE:
This appliance has a polarized plug (one
blade is wider than the other). This plug will fit in a polarized
outlet only one way. If the plug does not fit fully in the outlet,
reverse the plug. If it still does
not fit, contact a qualified electrician to install the
proper outlet. Do not change the plug in any way.
8
5
6 7
4
3
2 6
1
HANDLE ASSEMBLY
POWER CORD STORAGE
Your cleaner includes a combination cord cleat/cord holder: To
remove the cord, rotate the cord cleat until the power cord is
released
. Remove the cord from the lower cord wrap. Connect
the cord plug into a 120V/60Hz power supply.
As an additional feature the cord cleat serves as a cord holder
while the cleaner is in use. Rotate the cord cleat until it snaps into
the "Release" position, the top portion of the cord cleat forms a
cord holder. Snap the
cord into the holder
and the cord will
be held out of the way
while you vacuum.
To store the cord:
Rotate the cord cleat
into the "Storage"
position. Wrap the cord
around the cord cleat
and the lower cord wrap
. Snap the end of the cord plug over
the cord for secure storage.
C
B
A
A
B
C
8