Rockwell Automation 931S-B1C6D-DC Bridge Converter - Manuel (Page 4)

2
3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top part
of the housing by carefully pressing the latches
on both sides (1). Pull out the top part of the
housing and the electronics section until they
unlock (2).
3.3 Settings
Set input and output ranges, minimum input values
and measuring span via the DIP switches SW1
according to the following table.
1
1
2
Offset Excitation
Voltage
SW1
3