Regency Horizon HZ54EPV Large Gas Fireplace - Manuel (Page 18)

18
Regency Horizon HZ54EPV Foyer à Gaz
installation
Description Simpson
Direct Vent Pro ®
Metal-Fab™
Sure Seal
Attic Insulation Shield 12” 58DVA-IS N/A from FPI N/A
High Wind Vertical Cap 58DVA-VCH N/A
High Wind Horizontal Cap N/A N/A
Horizontal Square Termination Cap N/A 5DHT
Vertical Termination Cap N/A 5DVT
Storm Collar 58DVA-SC 5DSC
Restrictor Disk 58DVA-RD N/A
Colinear Flex Connectors N/A N/A
Adjustable Flashing 0/12-6/12 58DVA-F6 5DF
Adjustable Flashing 6/12-12/12 58DVA-F12 5DF1-2
Vinyl Siding Standoff 58DVA-VSS 5DVS
Vinyl Siding Shield Plate N/A N/A
Snorkel Termination 14” 58DVA-SNK14 N/A
Snorkel Termination 36” 58DVA-SNK36 (N/A - FPI) N/A
Basic Horizontal Termination Kit (A) N/A N/A
Horizontal Termination Kit (B) 58DVA-KHA N/A
Vertical Termination Kit 58DVA-VHA N/A
FPI
946-604/P Simpson Direct Vent -Vent Guard (Optional) 946-623/P AstroCap XL Horizontal Cap
770-994 Rigid Pipe Adaptor (Must use with all rigid piping) 946-506/P Vent Guard (Optional)
946-606 Starter collar reducer 5” x 8” to 4” x 6-5/8” 946-625 Vinyl Siding Standoff - AstroCap XL
Note: When using Metal-Fab Sure Seal Rigid Piping - please note that the Adaptor (4DDA) must be used in conjunction with FPI Rigid Pipe Adaptor (510-994).
Offset Pipe Selection: Use this table to determine offset pipe lengths.
Pipe Length
(L)
5” x 8” Venting For specifi c instructions on venting components - visit the
manufacturers website listed below.
Run (X) Rise (Y)
0” (0mm) 5-11/16” (144mm) 15-5/16” (389mm) Simpson Direct Vent Pro: www.duravent.com
9” (229mm) 10-15/16” (278mm) 20-9/16” (522mm) Metal-Fab Sure Seal: www.mtlfab.com
12” (305mm) 13” (330mm) 22-11/16” (576mm) Industrial Chimney Company: www.icc-rsf.com
24” (610mm) 21-7/16” (697mm) 31-1/16” (789mm) Note: Horizontal runs of vent must be level, or have a 1/4”
rise for every 1 foot of run towards the termination.
Never allow the vent to run downward - this could cause high
temperatures and may present a possible fi re hazard.
36” (914mm) 29-13/16” (757mm) 39-7/16” (1002mm)
48” (1219mm) 38-1/4” (972mm) 47-7/8” (1216mm)
Regency Fireplace Products . 6988 Venture St. . Delta, BC . Canada . V4G 1H4 . 604-946-5155 . www.regency-fi re.com
L676 & L900 DIRECT VENT FIREPLACE
• A Vent Guard is required when the AstroCap is installed above grade at 7 feet or lower.
• The Simpson Dura-Vent and Selkirk Direct Temp horizontal termination caps cannot be used in any applications.
• Only the AstroCap XL and Snorkels are certifi ed for horizontal terminations.
IMPORTANT NOTE