MARVEL Scientific MPRO30iMT - Manuel (Page 20)

FILLER PANEL KIT INSTALLATION INSTRUCTIONS (OPTIONAL)
20
Optional Filler Panel kit includes the following:
quantity 2 Cabinet Extensions
quantity 2 Kick plate Extensions
quantity 6 #10 x .50” sheet metal screws
The following tools are needed:
Phillips screwdriver
Scribe or sharp pointed object
Sharp 1/8” diameter drill bit and drill.
To install the filler panel kit:
1. Hold one cabinet extension to side of the ice machine, keep-
ing the 1/2” diameter holes to the outside. Line up the top
and front of the cabinet extension with the top and front of
the ice machine. Mark the 3 hole locations with the scribe.
2. Drill the scribed hole locations with the 1/8” diameter drill
bit. DRILL ONLY ENOUGH TO GO THROUGH THE CABINETS
OUTER SKIN. Do not drill past this point or you will drill to
the inside of the ice machine.
3. Reposition the cabinet extension to the ice machine and
screw in place with 3 of the sheet metal screws. DO NOT
OVER TIGHTEN THE SCREWS.
4. Repeat steps 1 through 3 for the other side of the ice ma-
chine.
5. Remove the screws securing the grille to the bottom of the
ice machine. Slide the kick plate extensions behind the grille
as shown. Replace the screws and tighten.
Filler Panel Kit
This Filler Panel Kit will add 3 inches to the width of the ice ma-
chine for installation into an 18 inch wide opening. Order one of
the following part numbers for the color you require:
P/N 42242831 White Filler Panel Kit
P/N 42242832 Black Filler Panel Kit
P/N 42242833 Stainless Steel Filler Panel Kit
Figure 24
(45.7cm)