Carter-Hoffmann HP65 - Manuel (Page 2)

Electrical
Requirements
Operating
Instructions
Installation
Operates on 120 volt, 60 Hz, 1 PH, 1920 watts, 16 amps, 6 foot power cord
with NEMA 5-20P angled plug.
The HP Saute Station has been designed for warming and holding bowls or
plates up to 11 3/4” diameter. It is intended to be placed on a shelf and
securely fastened to the wall.
1. Remove the cabinet from its shipping carton and remove all packing
materials are from the cabinet.
2. Check to ensure that the equipment manual is present and removed
from the packaging.
3. Read the equipment manual completely before installing and operating
the cabinet.
4. Place cabinet on shelf. Do not operate cabinet until it has been securely
fastened to appropriate shelf or location. NOTE: Shelf or mounting
location should have a weight capacity of at least 600 lbs. With the
full weight of the cabinet on the shelf, secure unit to the shelf with sta-
tionary clips provided, one on each end of the unit. These clips are
intended to keep the unit stationary only, and are not intended to support
the unit in any way. Mounting must meet all local building code require-
ments. Use only hardware that is intended for the wall material present
(hardware not included). Make sure unit is level, square and flush with
the wall before tightening bolts.
6. Clean cabinet thoroughly before use (see instructions on page 1).
5. Connect the cabinet power cord to a correctly wired and protected power
source.
1. Plug in the power cord. On/Off switch is located on front of cabinet. Red
power light on the left side of the switch will illuminate when power is
turned on.
2. For best results, allow cabinet to heat for 30 minutes.
3. Load clean dishes directly from the dishwasher into cabinet. Dishes
should reach required temperature within 15 minutes.
NOTES:
Loading cooled dishes into a warm cabinet will extend the heating time.
Loading cooled dished into a cold cabinet will extend the heating time to
as much as two hours.
Do not plug into ungrounded receptacle. Check to
ensure that heater plug is in safe operating condition.
WARNING