Napier 55 Series Truck Tent - Manuel (Page 2)

SHEET OF
10 2
5.
6. Insert the ends of each pole into their corresponding pock-
ets on the tent, first with the side-to-side (grey) pole (A) and
then the corner-to-corner (navy) pole (B). When you do this,
the poles will arch the tent. Attach the clips from the tent
onto each pole to support the tent.
Installation Instructions
1. Drop the tailgate of the truck to the down position.
2. Unfold the tent in the bed of your truck. Make sure the tent
door is facing the back (or tailgate) of your truck.
3. Loosely attach the three straps on each side of the truck by
hooking the middle straps under the wheel well and the
outside straps under the truck body.
The sides of the tent should slightly overlap the top of the
truck bed.
4. Loosely attach the three straps at the back of the truck
around the tailgate. The male clip slips between the truck
box and the tailgate and wraps around the tailgate to then
clip to the female clip under the tailgate.
7.
8. Open the door and insert the black inside pole (D) by
placing each end into the pockets located at the front and
back of the tent’s inside ceiling. Position the pole in the
center of the roof and secure it using the velcro straps (E)
sewn into the centerline hem of the tent. Once the tent is
standing, cinch the straps tightly around the truck bed to
ensure a snug fit.
B
B
B
B
C C
E
D
POLE IN POCKET
ASSEMBLY INSTRUCTIONS
Insert the poles into the corresponding coloured
sleeves.
Raise the tailgate pole (olive) (C) last by inserting each
end into pocket and fastening the tent clips to the pole.
A A
1-800-567-2434
Designed For The Great Outdoors
All tent products of Napier are patented under the United States and International laws © 2006
III III
III III
Patent # D461,759
2.17.09
REV. 11
Option: Refer to page 5 for instructions on how to install the
strap protectors. Install the strap protectors now.