Handle installation and removal – Whirlpool WRF560SEYW Manuel d'utilisation

Page 10

Advertising
background image

10

Handle Installation and Removal

Parts Included: Refrigerator door handles (2),
Freezer drawer handle (1)
Tools Needed:

¹⁄₈" Hex key wrench

Install Door Handles

NOTE: Handle mounting setscrews are preinstalled inside the
handle.
1. Remove the handles from the packaging inside the

refrigerator.

2. Open a refrigerator door. On the opposite door, place the

handle on the shoulder screws with the setscrews facing the
adjacent door.

3. Firmly push the handle toward the door until the handle base

is flush against the door.

4. While holding the handle, insert the short end of the hex key

into the upper hole and slightly rotate the hex key until it is
engaged in the setscrew.

5. Using a clockwise motion tighten the setscrew until the screw

feels tight.

6. Repeat steps 4 and 5 to fasten the lower setscrew.

IMPORTANT: When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.

7. Repeat steps 2 through 6 to install the other handle onto the

adjacent refrigerator door.

Install Drawer Handle

1. With the freezer drawer closed, place the handle on the

shoulder screws with the setscrews facing down toward the
floor.

2. Firmly push the handle toward the drawer until the handle

base is flush against the drawer.

3. Insert the short end of the hex key into the left-hand hole and

slightly rotate the hex key until it is engaged in the setscrew.

4. Using a left to right motion tighten the setscrew a quarter-turn

at a time. Repeat until the screw feels tight.

5. Repeat steps 3 and 4 to fasten the right-hand setscrew to the

shoulder screw.
IMPORTANT: When the screws feel tight, tighten them an
additional quarter-turn. The handle is not properly installed
without this extra tightening.

6. Save the hex key and all instructions.

Remove the Handles

1. While holding the handle, insert the short end of the hex key

into a setscrew hole and slightly rotate the hex key until it is
engaged in the setscrew.

2. Using a right to left motion loosen the setscrew a quarter-turn

at a time.

3. Repeat steps 1 and 2 for the other setscrew. Slowly pull the

handle away from the door or drawer.

4. If necessary, use a Phillips screwdriver to remove the shoulder

screws from the door.

A. Shoulder screws
B. Setscrews inside the handle

B

A

A. Shoulder screw
B. Setscrews inside the handle

B

A

Advertising