Whirlpool WRF991BOOM - Manuel (Page 31)

31
Doors
To view an animation showing how to adjust and align the doors, refer to the Product Help/FAQ section of the brand website and search
for “door closing and door alignment.”
Water is leaking or dripping
from the dispenser system
NOTE: A few drops of water
after dispensing is normal.
The glass was not held under the
dispenser long enough. Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
Water continues to drip
from the dispenser beyond
the first few drops. The refrigerator has just been installed. Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See “Water and Ice Dispensers.”
The water filter was recently installed
or replaced. Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See “Water and Ice Dispensers.”
Water is leaking from the
back of the refrigerator The water line connections were not
fully tightened. See “Connecting the Water.”
Recently removed the doors and did
not fully tighten water line connection See “Refrigerator Doors and Drawer.”
Water from the dispenser is
warm Water from the dispenser is chilled to
50°F (10°C). This is normal.
The refrigerator has just been installed. Allow 24 hours after installation for the water supply to cool
completely.
A large amount of water was recently
dispensed. Allow 3 hours for the water supply to cool completely.
Water has not been recently
dispensed. The first glass of water may not be cool. Discard the first
glass of water dispensed.
The refrigerator is not connected to a
cold water pipe. Make sure the refrigerator is connected to a cold water pipe.
See “Water Supply Requirements.”
PROBLEM POSSIBLE CAUSES SOLUTIONS
PROBLEM POSSIBLE CAUSES SOLUTIONS
The doors will not close
completely The door is blocked open. Move food packages away from door.
A bin or shelf is in the way. Push bin or shelf back into the correct position.
Recently installed Remove all packaging materials.
The doors are difficult to
open The door gaskets are dirty or sticky. Clean gaskets and contact surfaces with mild soap and warm
water. Rinse and dry with soft cloth.
The doors appear to be
uneven The doors need to be aligned, or the
refrigerator needs to be leveled. See “Refrigerator Leveling, Door Closing and Alignment.”
The refrigerator is unsteady
or it rolls forward when
opening and closing doors The refrigerator brake feet are not snug
against the floor Remove the base grille. Turn both brake feet (one on each
side) clockwise, the same amount, until they are snug against
the floor. See “Refrigerator Leveling, Door Closing and
Alignment.”
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.