Whirlpool WRF991BOOM - Manuel (Page 17)

17
Recommended Freezer Temperature
Adjust Temperature Set Points
Refrigerator set point range: 33°F to 45°F (0°C to 7°C).
Freezer set point range: -5°F to 5°F (-21°C to -15°C).
1. When Temperature mode is activated, press TEMPERATURE
to select the Refrigerator zone. The display will show the
temperature set point of the selected compartment, as shown.
2. Press LOCK to raise the set point, or press OPTIONS to lower
the set point.
3. When you have finished viewing (and adjusting if desired) the
refrigerator set point, press TEMP, under Select Zone, to
change the display to show the freezer set point. When the
zone has been changed, “FREEZER” appears on the display
screen.
4. Press the LOCK button to raise the set point, or press the
OPTIONS button to lower the set point.
Save/Confirm Temperature Settings
■ When you have finished adjusting both the refrigerator and
freezer set points, press MEASURED FILL to confirm and to
save the settings.
NOTE: To exit Temperature mode without saving changes, press
the ICE/WATER button under Back at any time, or allow about
60 seconds of inactivity. The temperature mode will turn off
automatically and return to the normal screen.
When adjusting temperature set points,
use the following chart as a guide:
Cooling On/Off
Your refrigerator and freezer will not cool when cooling is
turned off.
■ To turn cooling off, press and hold the LOCK and MEASURED
FILL buttons at the same time for 3 seconds. The Cooling Off
icon will blink seven times and then remain lit as shown.
IMPORTANT:
■ To avoid unintentionally locking the dispenser or changing
other settings, press both buttons at exactly the same
time.
■ When cooling is off, the dispenser paddles and all controls
except Lock and Measured Fill are disabled.
■ Press and hold LOCK and MEASURED FILL for 3 seconds
again to turn cooling back on.
Options
Press the OPTIONS button to open the Options menu and select
between Fast Ice, Filter Status or Vacation mode.
Press the ICE/WATER button at any time to return to the Normal
screen.
Fast Ice
The Fast Ice feature assists with temporary periods of heavy ice
use by increasing ice production.
■ To turn on the Fast Ice feature, press the OPTIONS button to
access the Options menu, then press TEMP, under Fast Ice to
activate the feature. When the feature is on, the Fast Ice icon
will appear on the dispenser display screen. The Fast Ice
feature will remain on for 24 hours unless manually turned off.
■ To manually turn off the Fast Ice feature, press the OPTIONS
button to enter Options mode (unless you are already in
Options mode), then press TEMP, under Fast Ice, again. When
the feature has been turned off, the Fast Ice icon will
disappear from the dispenser display.
Filter Status
Displays the percentage of use remaining in the water filter (from
100% remaining to 0% remaining).
To access Filter Status, press the OPTIONS button to access the
Options menu, then press OPTIONS, under Filter Status, to
display the percent of life remaining in the water filter.
ALSO
The water filter status lights will let you know when to change your
water filter.
■ ORDER FILTER (Yellow) - Order a replacement water filter.
■ REPLACE FILTER (Red) - Replace the water filter. Replacing
the disposable water filter will automatically reset the water
filter status tracking feature. See “Water Filtration System.”
CONDITION: TEMPERATURE
ADJUSTMENT:
REFRIGERATOR too cold REFRIGERATOR Setting
1° higher
REFRIGERATOR too warm REFRIGERATOR Setting
1° lower
FREEZER too cold FREEZER Setting
1° higher
FREEZER too warm /
Too little ice FREEZER Setting
1° lower
A. Press LOCK and MEASURED FILL at the same time.