Whirlpool W10277499 - Manuel (Page 5)

5
ROUND DOOR REVERSAL
INSTRUCTIONS
Remove screws from face
of door hinge
16.
Detach door from its original location by removing all four screws
from door hinge, as shown.
Remove screws and lift off top
of inner door assembly
17.
IMPORTANT: Avoid damaging or scratching door by laying
on a soft cloth in your work space.
Remove all six screws from door assembly, as shown,
to separate the innter door assembley from the outer frame.
Lift the inner door assembly off the outer door assembly. Set
the inner door assembly aside to work on later.
Then, remove both screws from side of door hinge.
Remove screws from gray panel
18.
Remove the four screws that hold the gray panel with glass
window to the door panel.
Then, remove both screws from side of door hinge.
Rotate gray panel
19.
Lift up the gray panel and rotate 180° so that glass window is in
the correct position to reverse the door. Then reattach with the
four screws that previously held the gray panel in place.
Remove bolt hole covers
20.
Your dryer will either have plastic strips or labels covering
the bolt hole openings. If you have plastic covers, use
a screwdriver to gently pry off plastic bolt hole covers. If your
bolt holes are covered with labels, gently peel the labels off.
Remove door hinge screws
21.
Remove all 4 screws attaching inner door to hinge.