Whirlpool W10277499 - Manuel (Page 3)

3
Snap off hinge plate cover and
move to other side of door
4.
Along edge of outer door ring, find removable plastic hinge plate
cover. Snap out and lock into slot on other side of door.
Rotate window panel
5.
Remove interior section of outer door ring from the frame, rotate
180° and snap back into place.
Remove bolt hole covers
6.
Your dryer will either have plastic strips or labels covering
the bolt hole openings. If you have plastic covers, use a
screwdriver to gently pry off plastic bolt hole covers. If your
bolt holes are covered with labels, gently peel the labels off.
Remove screws from hinge panel
7.
Move hinge to other side and
replace screws
8.
Remove all four screws that hold hinge to door frame,
as shown above.
Place frame in slot on other side of door and reattach, using
screws that were just removed.
Replace bolt hole covers
on other side
9.
Use bolt hole covers to avoid damaging previously used screw
openings on dryer door. If your bolt hole covers are labels,
you will find replacement labels with parts included with door
reversal kit. Peel replacement labels off paper backing and
press over bolt holes. If you have plastic bolt hole covers, you
may reuse them by snapping them into screw holes, or you may
replace with the provided labels as previously described.