Whirlpool WFW96HEAC - Manuel (Page 17)

17
REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use, vacation, winter storage,
or moving:
1. Refer to Installation Instructions to locate, level, and
connect washer.
2. Before using again, run washer through the following
recommended procedure:
To use washer again:
1. Flush water pipes and hoses. Reconnect water inlet
hoses. Turn on both water faucets.
2. Plug in washer or reconnect power.
3. Run washer through HEAVY DUTY cycle to clean washer
and remove antifreeze, if used. Use only HE detergent.
Use half the manufacturer’s recommended amount for
a medium-size load.
Today’s liquid HE detergents are concentrated. Most brands of
concentrated HE detergent will show the level of concentration
on the bottle. If so, simply set the concentration level in the
Precision Dispense menu to match the level shown on the bottle.
However, if the detergent bottle does not give the concentration,
it can be easily calculated. Just divide the package size in fluid
ounces by the number of loads. Then refer to the chart below to
find the concentration.
If you do not get your desired cleaning results, try using a lower
concentration number. If you have excess suds, try using a higher
concentration number.
ABOUT DETERGENT CONCENTRATION
Concentration Number of ounces ÷ number of loads
2X 1.5–2.49
3X 0.9–1.49
4X 0.7–0.89
5X 0.5–0.69
6X 0.3–0.49